The DigiCAT 650i provides a unique data capture and on board memory function, allowing verification of the locators use and the ability to recall records following a near miss, service strike or similar incident.
The DigiCAT 650i locates buried conductive services by receiving electromagnetic signals which radiate from them. The EZiCAT's intelligent software interprets the signal data and provides the operator with an audible response to the location and direction of buried utilities. The operator can mark the ground or use a GIS mapping device to note
the location. With the unique LOGiCAT VU Software, records can be retrieved and collated helping to
increase on-site safety, whilst identifying training needs.
Data Logging:
Both the DigiCAT 600i and 650i record and store detection information whilst in use. The locators
start to record information every second after completion of the initial start-up routine. These
records (logs) are stored in the locator's memory and can be retrieved and transferred via
Bluetooth to a PC for analysis. The locators are capable of storing approximately 80 hours of
records.
Bluetooth Wireless Connectivity:
Both the DigiCAT 600i and 650i locators have the added benefit of Bluetooth wireless connectivity.
It allows the DigiCAT to integrate seamlessly with mobile mapping technology to log survey data,
in addition to enabling wireless Bluetooth data transfer.
Depth Indication:
When using the DigiCAT in conjunction with the DigiTRACE or Sonde in 8 or 33 kHz modes, operators can determine the depth of the buried utility, providing a clear advantage when conducting ground surveys.
Additional information:
Dual mode active tracing for on-site flexibility
Controls: On/Off, Mode select, 'i-button' Information select & view
Frequencies: Power 50/60 Hz, Radio 15-60 kHz, Generator 8 & 33 kHz
Depth range: Power/Generator 3 metres, Radio 2 metres
Dust & water protection to IP54
Eica DigicaT 650i caBlE aVoiDancE ToolS